14 Dulwich St., Loganholme, Queensland, 4129, Australia
P07 3806 1944 (+617 3806 1944) F07 3209 7711 (+617 3209 7711)

 

  

  Click for home page Click for Sales Agents

Compatibility of Paints with

FERONITE Rust Converter and

FERONITE Rusty Metal Primer

 

 

GOOD

Enamel

Alkyd

Acrylic – solvent based

Acrylic – water based (but many are unsuitable for steel protection).

Epoxy

Coal Tar Epoxy

High build epoxies

Micaceous iron oxide

Synthetic resin

Catalysed urethanes (2 pack)

 

GOOD – but

Alkyd / long oil types – possibly long drying

Chlorinated rubber – possibly long curing, softer but dry eventually

Nitro solvent based – can soften

Water based vinyl emulsions – need intermediate primer to avoid bleed

Solvent based vinyls – require intermediate acrylic bond coat

 

PRIMERS CONTAINING THE FOLLOWING PIGMENTS SHOULD NOT BE APPLIED OVER FERONITE RUSTY METAL PRIMER

Zinc dust  (zinc rich primers)

Zinc chromate

Zinc phosphate

Strontium chromate

Copper powder (anti-fouling paints)

Magnesium borate

Graphite

Carbon black (in high concentration, e.g. in conductive paints)

 

Feronite Rusty Metal Primer contains anti-corrosive pigments, therefore the use of the above primers would have little if any additional anti-corrosive protective effect.

 

NOTE

Some primers contain a strong solvent which can leach a trace of tannin which leads to a brown streak appearing.  This is not recommenced rusting, and subsequent painting will conceal the streaking.

RECOMMENDATIONS

Epoxy undercoats followed by polyurethane topcoats are most recommended for marine applications.

 

Information is based on tests by the British Paint Research Association.

 

This product should only be used in accordance with instructions on the container label or written instructions from the company. This is not a specification and all information is given in good faith. For application in special conditions, consult BoatCraft Pacific Pty. Ltd. or an appointed agent for detailed recommendations. The manufacturer warrants that its products have been manufactured under strict control to its normal standards. The performance of the product will vary according to the nature of the surface to which it is applied and the preparation and the mode of application. As the manufacturer cannot supervise the above procedure no warranty as to fitness of the product for a particular purpose can be given provided that nothing herein shall be deemed to exclude, restrict or modify any conditions or warranty expressed or implied by any statute whether State or Federal.

Enquiries 

Please call Boatcraft Pacific 07 3806 1944 ( +617 3806 1944) for how to contact your nearest reseller.

Copyright Boatcraft Pacific Pty. Ltd.