The one cover for most purposes. The high absorption micro-fibre means it rolls further with less spatter, has minimal fibre shed and givs a smooth finish with all paints. 10mm nap.
Usage instructions.
Rinse in water before use to remove any loose particles, then allow to dry.
Slide cover onto frame. Fill well end of tray with paint until level with the roller ramp.
Dip cover into paint and roll on ramp to coat evenly. Avoid over-loading roller.
Spread paint in light even strokes and in varying directions until the surface is well covered.
Roll back over painted surfaces with long light strokes in a single direction to smooth.
Avoid re-rolling over partially dry surfaces.*
After use, use a wire roller cleaner to squeeze out as much excess as possible.
Roll out further excess on old newspaper.
For Aquacote, wash roller thoroughly in warm water.
Rinse then wash in warm water to which a little detergent has been added
Finally rinse thoroughly in clean water and stand up to dry in a warm shady place before storing, do not soak or store wet in a plastic bag, this can lead to the roller rotting and suffering fibre loass.
*Very important with Aquacote.
This product was added to our catalog on Sunday 05 July, 2009.
