46 Chetwynd St., Loganholme, Queensland, 4129, Australia
P07 3806 1944 (+617 3806 1944) F07 3209 7711 (+617 3209 7711)

 

  

  Click for home page Click for Sales Agents

FERONITE RUSTY METAL PRIMER

Introduction. Compatibility. How it Works. Treatment Specification.
Tech Data Sheet. Typical Film Properties. Marine Artifact Treatment. Conserving Carpentaria.
Rusty Metal Primer Safety Data Sheet. Rust Converter Safety Data Sheet.

TYPICAL FILM PROPERTIES

 

FILM THICKNESS.

For best protection on steel a film thickness of 50 - 65 u above the surface profile is recommended.

ADHESION

Feronite Primer adheres well to a variety of substrates including steel, cast iron, phosphated steel, galvanised iron, concrete, and most paints including shop primers.

MECHANICAL PROPERTIES

Feronite Primer has a good balance of hardness, flexibility and abrasion resistance.          Typical results for a 65 u film are as follows:

Falling weight

3 mm indent

pass

Flexibility

6 mm bend

pass

Erichsen test

10 mm indent

pass

(DIN 53156)

 

 

Scratch hardness

 

2000 gm

Properties of an unsupported film are

Yield stress

1

MPa

Ultimate tensile strength

2,5

MPa

Water vapour permeability

20 gm/25 u thickness/m2/24 hr

CHEMICAL RESISTANCE

Feronite Primer when fully cured resists spillage from a wide range of corrosive chemicals including strong acids and alkalis, aliphatic solvents, alcohols, glycols, petrol and diesel oil. Not resistant to immersion in aromatic solvents, animal or vegetable oils, It is resistant to immersion in both salt and fresh water, (However, long term corrosion protection is entirely determined by the type and thickness of paint topcoats applied), 

This product should only be used in accordance with instructions on the container label or written instructions from the company. This is not a specification and all information is given in good faith. For application in special conditions, consult BoatCraft Pacific Pty. Ltd. or an appointed agent for detailed recommendations. The manufacturer warrants that its products have been manufactured under strict control to its normal standards. The performance of the product will vary according to the nature of the surface to which it is applied and the preparation and the mode of application. As the manufacturer cannot supervise the above procedure no warranty as to fitness of the product for a particular purpose can be given provided that nothing herein shall be deemed to exclude, restrict or modify any conditions or warranty expressed or implied by any statute whether State or Federal.

 

 

 

 

Enquiries 

Please call Boatcraft Pacific 07 3806 1944 ( +617 3806 1944) for how to contact your nearest reseller.

Copyright Boatcraft Pacific Pty. Ltd.

Boatcraft Pacific, 46 Chetwynd St., Loganholme Qld. 4129 P 07 3806 1944