Product Information Pages

46 Chetwynd St., Loganholme, Queensland, 4129, Australia
P07 3806 1944 (+617 3806 1944) F07 3209 7711 (+617 3209 7711)

DESCRIPTION T-88 is a 2-component, solvent-free epoxy/polyamide adhesive. T-88 meets the specification requirements of MIL-A-81236(WP) and CID A-A-3053.

RESIN PROPERTIES:

Viscosity @ 25°C(77° F)................................ 9000-11000 cps

Specific Gravity ............................................ 1.10-1.12

Color ................................................................... Clear

HARDENER PROPERTIES:

Viscosity @ 25°C(77° F) .................... 8000-10000 cps

Specific Gravity ........................................... 0.. 95-0.97

Color ................................................................ Amber

MIXED SYSTEM PROPERTIES:

Mix ratio by weight resin/hardener...................................................... 100/83

Mix ratio by volume resin/hardene..................................................... 100/100

Working time @ 25° C............................................................ 40-60 minutes

Tack-free time @ 25° C.................................................................. 4-6 hours

Coverage....................................................................................... 80 ft²/gal

Maximum Service Temperature............................................................ 160°F

TYPICAL CURED PROPERTIES:

Lap-Shear Strength, psi.
Polyester Laminate	.2800*	Aluminum	2000
Concrete	1100*	Galvanized Steel	1800
Wood(Maple)	.1800*	Copper	.1650

*Indicates substrate failure

Tensile Strength, psi............................................................................................. 7000

Tensile Elongation at break................................................................................. 7.5%

Flexural Strength, psi................................................................... 11,500

Flexural Modulus, psi.................................................................. 375,000

Compressive Yield Strength, psi ................................................... 12,500

Heat Deflection Temperature, ° F........................................................ 119

Lap-Shear Strength vs. Temperature:		(Aluminum Tensile Shear):
	67°F	2500psi
	75°F	2000psi
	150°F	1300psi
	180°F	1000psi

All tests were conducted in accordance with ASTM procedures.

Sizes available(kits): 8 oz. / 16 oz. / 32 oz. / %2-gallon / 1-gallon / 2-gallon / 10-gallon / 110-gallon

For health and safety information concerning this product, please refer to the MSDS sheets for T-88 Structural Adhesive. MSDS sheets are available on our website at www.systemthree.com.

The information contained herein is based on the data available to us and is believed to be correct. However, System Three Resins, Inc. makes no warranty, expressed or implied, regarding the accuracy of these data or the results to be obtained from the use thereof. System Three assumes no responsibility for injury from the use of the product described herein.

Enquiries

Please call Boatcraft Pacific 07 3806 1944 ( +617 3806 1944) for how to contact your nearest reseller.